To get the best longevity out of your Cloudster Pillow IWB Holster Wedge, please see the recommended Care Instructions below.

Instructions for Your Cloudster Pillow

Follow these steps to ensure optimal comfort.

1. Unpack and Adjust the Fill:

• Your pillow comes fully packed. Start by removing some of the fill.

Then slowly add fill to find the desired comfort level.

2. Prepare the Holster:

  • Use the provided alcohol wipe to clean the area of your holster where you plan to place the loop side of the Velcro.
  • Allow the alcohol to completely dry.

3. Attach the Velcro:

  • Peel off and firmly press the Velcro onto the cleaned area of your holster.
  • Hold it in place for 30 seconds to ensure a secure bond.
  • Adhesive reaches maximum strength after 24 hours.

4. Test the Fit:

  • Attach your Cloudster Pillow to the Velcro on the holster.
  • If the pillow feels too bulky, remove more fill. If you can feel the holster through the pillow, add some fill back in. Also, try moving the pillow up and down and side to side.

5. Adjust for Comfort and Concealment:

  • You can position the fill inside the pillow to the sides or bottom to create a wedge effect for better concealment.
  • For a bigger wedge, add a little extra fill to the spots where you want the wedge to engage with the holster.

6. Care Instructions:

  • Wash the pillow by hand in lukewarm water using mild soap.
  • Allow the pillow to completely air dry before use.
  • To re-fluff your pillow, close it securely to prevent foam from escaping and place in dryer on regular heat for 5-10 minutes.

By following these instructions, you can customize your pillow for the perfect balance of comfort, functionality, and concealment.

Enjoy your new level of comfort and convenience!